![]() The time to the last shot willīe displayed. Quick Start If you want to get started right away, all you have toĭo is press the POWER ON button, then the START button on the side,Īnd shoot (You can also tap on the front of the case near the A new battery will pro- vide approximately 20 The back of the unit, connect the battery to the snap clip and Volt alkaline battery.To install the battery, remove the cover on The display will show “PAr” for 1.5 seconds, followedīattery Installation/ Status The Pocket Pro timer operates from a 9 2nd BEEP- To set a second beep (par time) begin by holding down the 2nd BEEP button. Holding down the NUMBER and SPLIT buttons while pressing the REVIEW button will review split times in reverse order. Holding down the SPLIT button while pressing the REVIEW button will review the split times. SPLIT- This button displays the time difference between the current shot and the previous shot. This button also changes digits in the 1’s place when setting a second beep (par time). ![]() NUMBER- Pressing the NUMBER button will show the number of the shot currently being displayed. This button also changes digits in the 10’s place when setting a second beep (par time). ![]() If you hold down the NUMBER button while you press the REVIEW button the shots will be reviewed in reverse order. When the button is released, the time from the start beep to that shot is displayed. The shot number is displayed as long as you hold the button OR for. REVIEW- After your last shot, you can review other shots by pressing this button. Looking at the front of the case left to right you will see Review, Number, Split, 2nd Beep, and Power ON buttons. The Inst (Instant) setting will provide an in- stant start, and the Rand (Random) setting will provide a delayed start of 4 to 6 seconds. The markings for its setting are on the case front near the edge. Setting the Start Delay The start delay slide switch is located on the side of the Pocket Pro near the start button. Doing so may prevent proper sound pickup and/or coupling of the buzzer sound into the sensor causing a false shot to be recorded. When operating the Pocket Pro be careful not to cover the sensor opening with your hand. The shot sensor is located next to the buzzer on the front of the case. The timer can record and store up to 99 shots for a given timing cycle. Shot Detection Each time a shot is detected, it will be added to the “shot string” maintained within the timer. ![]() The last shot string and 2nd beep (par time) setting will be saved in power down memory. It will turn off by itself after 10 minutes of inactivity. To reset the Pocket Pro, press the start button again. The time to the last shot will be displayed. Quick Start If you want to get started right away, all you have to do is press the POWER ON button, then the START button on the side, and shoot (You can also tap on the front of the case near the sensor open- ing to simulate shots). When the battery becomes deplet- the display during use. A new battery will pro- vide approximately 20 hours of use. SHOT TIMER OPERATING INSTRUCTIONS rev.3 2010 Battery Installation/ Status The Pocket Pro timer operates from a 9 volt alkaline battery.To install the battery, remove the cover on the back of the unit, connect the battery to the snap clip and reinstall the cover. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |